There are several ways to fix a hole in a door. The trick is to know what to do and how to do it. It may not be as easy as you think, and it does take some effort. In general, repairing a hole in a door is a reasonably safe job, though there are still a few hazards. However, you should be careful to make sure the area is structurally sound before attempting any repairs.
First, you should prepare the surface. This includes getting rid of any loose debris and splinters. A sharp utility knife is a great tool for this task. Holding the blade at a slight angle, you can clean up the edges of the hole. Using a utility knife is also an excellent way to trim the edge of a hole.
You can also use a NT cutter to get the job done. These small woodworking tools can be handy, but the bits can be a bit sharp. To make your work easier, you can place a drop cloth beneath your work area. If your door is hollow-core, you can even place a tarp beneath the hole.
For a more permanent solution, you can paint your door. If you have an old solid wood door, you can wedge a small wooden dowel into the hole. Make sure the dowel is the same width as the hole. Next, coat the dowel with carpenters glue. When the glue dries, it will act as a filler for the missing piece of the door.
Another way to repair a hole in a door is to cover it with insulation foam. This will prevent the foam from falling to the floor. It’s not very effective, but it’s better than nothing. While it does make a good insulation block, it won’t offer structural support.
Alternatively, you can use cardboard to surround the hole. This is much more sturdy than paper towels, and it’s even a little stronger. If you have a lot of cardboard lying around, you can roll it up to enclose the hole.
After you’ve made your final preparations, you’re ready to get started. If you have a hole in your door, you should be prepared to devote a couple of hours to the project. That’s not to say you have to do it in a rush. Take your time and pay attention to the steps. Taking the time to do this will ensure that you get the most out of your effort.
To complete the task, you’ll need a few inexpensive but essential tools. A utility knife is an essential piece of equipment, although it may be a little intimidating to use. It can be used to trim the edges of a hole, but it’s best to take your time. Putting the right amount of attention to detail can make a difference between a satisfactory job and one that doesn’t come out looking quite as nice.
The best part is, you won’t have to buy a new door. Once you’ve completed the project, you can replace the hinges and your door will look brand new.
Also Read: Low Profile Barn Door Hardware